To clean surface while epoxy is still wet/uncured wipe up as much material as possible and clean any remaining product/residue with Isopropyl alcohol (IPA) or acetone used to manufacturer’s instructions or soap and water. Wipe tip clean with dry cloth and align notch on tip and cap.
Storage: To close, pull plunger slightly back. Handling: Allow to cure for 30 minutes undisturbed (no weight or handling)įinal Cure: Allow 24 hours for load-bearing weight To reach maximum bond strength, clamp project together and leave undisturbed. The epoxy mixture will continue to thicken and the bond strength will decrease the longer you wait to apply. This is a reaction that occurs as the resin and hardener combine.Īfter mixing is complete, apply Gorilla Epoxy within 5 minutes. Apply within 5 minutes.Īs you mix, you will notice that the epoxy warms up. Mix the two parts for about 20 seconds, until the mixture is uniform. Once the flow is even, move to the larger mixing well to dispense your even ratio. If you flip the plastic blister shell over, you can use the small well as a starter dish to begin dispensing until both the resin and hardener are flowing equally. The package itself can be used as a mixing tray. Push the plunger to dispense even amounts of resin and hardener onto a clean, disposable, contained surface. With the tip still pointing upward, eliminate air and ensure even dispensing by slowly pushing the plunger until both the resin and the hardener are at the tip.
With tip pointing upward, cut or snap the end from tip of the syringes. Remove the black cap from the two syringes. Then clean and dry all surfaces to be bonded. Prepare the surface: To improve adhesion, roughen smooth surfaces before gluing. Gather your mixing tray and stir sticks so that all your supplies are together. Be sure your work area is protected from spills. Prepare your work area: It is recommended to use Gorilla Epoxy in a well-ventilated area. If you’re using Gorilla Epoxy for the first time, or bonding a new type of material, we always recommend trying a test piece first.
0 kommentar(er)
